Thread: Cosworth 90mm Head gasket finaly avalible!

Ah, so this has the extra oil hole for universal fit?

DO they make a stock bore gasket for the VE ?

You use the 87mm gasket for the stock bore.

In my built block I have the Cosworth 87mm gasket and the main/rod bearings.

SBR a forum vendor sells them on there site I think

Cosworth & Mazworx 90mm Headgasket are both very good in my books.

Here's the differences between the gaskets:

Cosworth a single fold "Stopper Type"



Mazworx/PE is a "Full Grommet Type"



Cosworth, easier to produce=lower cost
Mazworx/PE, harder to produce= higher cost

Mazworx/PE has the VE oil hole

Both produced at the same plant (don't know for fact, but obvious by construction)

Only one of the gaskets has been proven to 60 lbs of boost and 1300hp


Mark
[email]mark@mazworx.com[/email]

do you guys make one for a 87mm bore?

I was about to ask the same question.

The Apexi is the same style as the PE / Mazworx and comes in 88mm model (for a 87mm bore) PN: Apexi 88mm 1.1mm 814-N106. Thats what I have.

thanks homie!