Blowing oil out the dip stick only when in higher boost. Bad headgasket?
Please read this carefully. OK so recently while I was on the highway doing a high boost run. My car started to smoke like hell. I thought I blew the motor. But it ran fine after I let off. But still smoked. When I pulled over and popped the hood to see what was going on oil was EVERYwhere in the bay. At first I thought it was my oil feed line. But even on a cold start up with 50plus psi it isnt leaking a drop. Then I noticed my oil dipstick was wet along with the spray pattern pointing to the dipstick hole.
Anyway the car runs fine and will build boost and all that. Idles well and everything. Doesnt get hot or anything. Vacuum is also good. Everything on the car has been the same for over 3 years. Vacuum lines are good and routed right and all. But when I hit boost (like anything over 12psi) oil blows out of the Dipstick everywhere in the bay. Obviously somehow the crankcase is getting pressurized. Could it be a bad head gasket or could it be a ring? Head lifting? All of those are good possibilities in my head. But out of all of them 2 of the three at least will make the car run like ****.
Havent done a compression test yet. But I will as soon as I have time and its not raining. But anyone had this happen to them?
Anyway the car runs fine and will build boost and all that. Idles well and everything. Doesnt get hot or anything. Vacuum is also good. Everything on the car has been the same for over 3 years. Vacuum lines are good and routed right and all. But when I hit boost (like anything over 12psi) oil blows out of the Dipstick everywhere in the bay. Obviously somehow the crankcase is getting pressurized. Could it be a bad head gasket or could it be a ring? Head lifting? All of those are good possibilities in my head. But out of all of them 2 of the three at least will make the car run like ****.
Havent done a compression test yet. But I will as soon as I have time and its not raining. But anyone had this happen to them?