Thread: Ecu cable popped out........

I was about to install my new 4 wire 02 sensor, so I decided to swap out my Calum and use the stocker to test everything out. While I was disconnecting the ecu, one of my wires poped out of it's socket behing the ecu (Part of the wire harness) Now I'm stuck trying to figure out hoe to remove the little gold/bronze tip inside of the blue ecu housing. Also, where can I buy a replacement of the tip that goes into the blue housing that holds the wire into the blue housing?

so... the wire end came off from the wire?

IF so, then you should just get another wire from a junk yard, remove the old pin from the ECU plug, and slide the new wire with pin into place.

Once that is done you can just splice your new wire to your old one.

I'm having problems getting that bronze tip outta the blue housing. Thanks for the quick responce I'm anxiouse......

Bump.... Any advice?

get a little flat head or just a point and stick it in there and push that sucker out lol

And will that also work when taking out the replacement one without damaging it?

http://www.honda-tech.com/showthread.php?t=587460

Thanks I'll give that a try and return w some feedback. Hope it works