Thread: HELP GTiR Swap need info

I need info on where to install resistors for low imp inj on my harness and any other info I need to know about the swap. I have been searching all over the forum for a how to and I seem to not find one. To everyone that is willing to helps thanks hopefully I can make a how to for everyone here if I can find out how to go about with this swap.


-Raf

i'm pretty sure you can wire them in directly before the injectors.

You wire them into the signal wire going to each injector, so the wire will not be the ground wire. To do this really clean, you can find the wire thats showing at each injector harness, and wire the resistor in at the ECU's side, but to make GTi-R injetors work you have to cut the injector harness to put the new ends on it... it all depends how far you like taking it to make it clean

The signal wire is the ground wire.

The injs all share the same positive wire which are all the same color. The diffrent color wires are the ground wires. The ECU clicks the ground wire on and off which is how the injs work.

When you get the resisters from JWT you put them on the ground wire.

thanks for clearing that up, makes more sense now

i put mine in by the ecu get the pinout guide for our computers, theres like 5 different links with different ones. Infact just google it and it will pop up. The numbers are something like 111, 109, 114, and 110 not sure exactly but something like that