Thread: clutch almost new and it's slipping.?

first sorry for my english.

a month ago, I broke the bellhousing transmission. there was a oil leak, and I was driving for 2 hours with low level of gear oil.

I disassemble the transmission, I fix the bellhousing fisure and the oil leak.
Everything was fine, only the fisure and the oil leak.

I bought my clutch 1 year ago, it's a LUK brand and I do not use it for racing, only a few times. I think that it is almost new.

Now, when I installed the transmission, the car feels like if the clutch is slipping.

Before the fisure. The clutch works fine, without slipping.

I think that I was install something wrong, or maybe I broke my transmission.

thanks

Did any fluid contact the clutch surfaces or the pressure plate surface or the flywheel surface?

is it cable? maybe u adjusted it too much?

second this...check the clutch cble and see if its adjusted properly

I already check the clutch cable and still slipping

Maybe u didn't tighten the pressure plate all the way?

if you got oil on the clutch disk at all your out of luck on that. Its going to slip. Nothing you can do. You would need a new disk and clean the pp and flywheel up very very good before installing a new disk.

did you beat on the clutch and did you go througha break in period with it before beating on it