Thread: Map trace problem

This might have been answered but I can't see to find it. I'm trying to setup my map tracing values and I put in the values on the first post for the b14 and I'm only getting a 3200 rpm and high tp. Is there something else I need to do?

B14 SE-R 95-97 (G20 94-97) Map Trace Values:

RPM MSB - 3472
RPM LSB - 3471
TP - 314E

Timing map - ED00
RPM Scale (timing) - E480
TP Scale (timing) - E490

Fuel map - E100
RPM Scale (fuel) - E0E0
TP Scale (fuel) - E0F0

Any help greatly appreciated!

try using all uppercase values.

Did, it wouldn't work with lower e's

and the 0's are Zero's correct?

Figured this out, I had the RPM and TP mixed up :/ lol

What program are you using to map trace?

Datascan

I thought so could you print a picture of your map? I thought that feature only worked for the z32?

Works on everything, check calums forum on the non dash. Now I need to figure out how to make the TP in tuner pro larger because when I did my run it came to like 80+ TP

This is a 4th gear pull

Did another run, this is 2nd thru 4th with decel on there also, going a little to fast to pay attention to laptop
This is with the TP that is actually on Tuner Pro. The one above you can see goes way past but it's still reading. Should've we be able to tune that or will it not matter?

When I did a map trace on my b14 all the values where scattered around and messed up. They were not organized like yours above.