Thread: CS dogbone mount install issue.

What if you lower it down into the bracket from top? Is that possible?

I say you drop the xmember all together after you've psuedo tightened the tranny and pass side mounts. Then work from the front to the back (put the front mount on first, then put the rear crossmember bolts in, etc. etc.) Careful watch the motor as you tighten back up the xmember though, don't want to put the motor in an awkward position.

sent it to me, ill test it out for you

Motor mounts dont have to be a pain

JWT - Nismo mounts are an easy install.

Everything else gives problems.

Here is my aluminum mount I sell. It fits perfet the first time.

ok so i've searched but cant find any info on these solid mounts.. how much do yours cost miko?

What pisses me off is that the stock dogbone mount bolts back in, in all positions, There is no way I'm using the dam stock dog bone again. That piece Andreas has looks like it would be perfect. Im going to put 1 more day into this and im done. Too fricking hard working in the cold A$$ rain man.

Yes I would like to know as well.

Dre, this is not the mount you sold me. Mine only came with one bushing.

the one with the one bushing is better than the mine in my pic. I am sure you liked it and it worked and fit perfectly.