Thread: putting 01 g20 rr engine in b13 ??

I have a rr engine from 01 g20 that i bought for cheap w/ pretty low miles.
Anybody know the difference of swapping this engine in as opposed to a regular sr20de in a b13 sentra. any modifications that need to be done? Can I use my stock ecu? It is just sitting in the garage for now until my time off from work I have coming up. I have searched and have not seen this topic posted.
Any help would be appreciated.

sensors on that motor are different... like tps,iacv,connections for egr also water temp

to make it work on b13 youll need
b13 se-r wiring harness,tps sensor,b13 se-r ecu,water temp sensor,53j maf,and youd have to use b13 se-r distributor

thanks

any opinions on a basic t25 set up on this motor...I was going to get a jdm de then turbo that but the price on thise engine was too good and I could not pass on it

yea dont put turbo till motor is in an works properly.. then buy t/25,manifold,j-pipe,all gaskets,jwt ecu,370cc injectors,walbro 255 fuel pump, fuel pressure regulator with gauge

then hav someone tune it

if you dont have all th fuel components i mentioned you will destroy inside of motor.

Leave the RR TPS right where it is at. Dont touch it otherwise you will be introuble.

you should back your claim with why you shouldn't instead of just making your comment andreas because the next question that everyone is going to ask is why not?

i dont think you need all of that, ya the wiring harness, you need to swap out the injectors, or install a resistor i the wiring harness, or the car will not start. the distributor yes, the TPS i dont think so.

my buddy put one in his 95 200SX SE-R, and the only thing he changed was the Dizzy, and installed that resistor.

I went to take a look at the engine today...besides leaving the tps where it is..am I just swapping over all sensors so that I may use my harness? In relation to a b13 only is there any sensors on a rocker roller engine that must not be swapped for this to work. As I am looking there are wayy more b14 w/ this swap done hands down.

AB13 TPS does not fit on a RR TB. It bolts on but the little arm will not move with the TB.