Thread: converting a G20 auto to manual w/ b13 se-r parts

So can I use my b13 ser pedals and all those stuff needed to make g20 manual with my se-r or will I still have to get some parts from a g20 manual?

I see some clean g20 for cheap but there all automatic

Thanks in advance

You probably just need the clutch pedal. You can replace the brake pedal, or just cut it smaller on the left side where the clutch will sit.

It's been a long time, but I believe you need the front, rear, and tranny motor mounts and brackets from a g20 and I believe that the shift linkage has to be from a g20 also.

the motor mounts are different for a manual I can't use the ones that come with the g20 and just get the shift linkage?, what about axles?

yes

so auto tranny mounts on g20's are different then manual g20's

so far i need:
shift linkage
outter axles
tranny mounts
clutch pedal
????

here was my b15 list, some items are obvious:

slave cylinder
master cylinder
clutch
flywheel
pressure plate
brake, clutch pedals
shifter rod
manual mount
clutch fluid reservior
clutch line/clip

Ok, now do all those parts need to come from the g20 manaul or can I use my b13 ser manaul part to do the conversion?

No idea. check g20.net? I'd play it safe and go with g20 parts, OR call gregv and ask him. He can cross reference all parts for you in a matter of minutes.

What year is your g20? Also, one of the axles are the same between auto and manual, so you really only need to find one manual axle. I don't remember which one it is, but I believe it's the drivers side axle that is different and you need to find, you might want to search around to double check.