Thread: heater controls only work on #4

well i need my heater controls to work because its going to be winter soon, and when my cars temp get up there i turn it on so i dont overe heat....


so how can i fix this? 1-2-3 setting dont do a damn thing nowwhen they ALWAYS worked for me.....

other wise i need a quick way to make a manual swithc for my rad fans so i dont over heat...

Lol I have it the other way around.

1-2-3 work 4 turns off.

damn you!!!!

but serioiulsy...until i get my new rad from insane imports, i need to fix this so i dont overheat, even know its like 50 degreess outside....


who knows of a quick way to turn on my rad fans while the ignitiopn is on?

blower motor resistor, do some research yo!

Blower resistor 27150-62J01 Sentra, NX2000

http://www.se-r.net/car_info/problems/blower_resistor.html

this has been common knowledge for about the past ten years.

sqweet thanks dudes.....now to rip the dash apart....

You don't have to rip the dash apart. Just reach under the dash where the blower motor is and unplug it and plug in the new one and all will be good again.

^^k will try

Same salution for 123work 4 doesn't?

That could be the selector switch on the HVAC controls... It melts on the 4 position.

Switch-Fan
27660-50Y00 is the part number.