Thread: P11 Prothane's!!

The Prothane's!


Both installed on the crossmember

Rear Mount


Front Mount


Fronts on the car


Rears on the car




They're about $70 a pair shipped.

Get them from Greg V at G spec!

if the pictures don't work, go here

Motor Mount, Passengers side (G20 x-member, see notes), FITS: B13 & G20 (See bottom) Our mounts are

Whats up with the center of that mount? Mine look nothing like that and neither does the one in the link. Is that something you modified and what did you do?

nope. the mount I used does not need any shaving, pressed right in. it's one solid piece = more "SOLID" than the 2 halves.

Blair these mounts Keo used are waayy better than the senta mounts because they are solid and press right in,I have the 2 piece sentra mounts and they kinda suck.I will be upgradin to these mounts soon

Keo do you know anything about fitting the P11 crossmember on the P10?

Should fit SGTSR20. Serban has one on his P10.

Keo, where are these mounts found? I got the 2 piece sentra one for my rear mount and shaved down the one piece one and stuffed it in my P10 front. There was a write up by Mark IIRC on G20.net a while back that described how to do this. I figured that was the only way to go? What's so different about what you are using? Obviously we are talking P10 vs P11 but they both share the same rear mount.

I've seen the how-to's on g20.net. I just don't think a 2 piece poly mount is as solid as a 1 piece. if it was, they would've made them all 2 piece to make them easier to install.

after looking at alot of mounts for other cars, they only use a 2 piece mount on the timing cover part of the mounts. that area don't take much abuse as the front and rear's (radiator/firewall side) so I figure it give some slack. plus, after hearing Trey saying that his engine still move with his 2 piece prothane, I didn't want to waste my time with that and I found this.

whats the part # on those mounts? the one's on Greg page are the Sentra ones...

#14-504

send Greg a PM or give him a call. he can get them for you.

Keo sir, you just made my day man!!!!!!

I asked you about this on G20 net and you were in the process of fitting them, Im so glad they worked!!

Have you had a chance to see if the engine moves? And does it vibrate a little bit, my personal opinion is: if it doesnt vibrate you might as well have left the stockers in place.