Thread: ** Gauging Interest - New pulley? Something machined?

I'm looking to do another run of pulleys. Are there any other pulleys i should consider making?

Power Steering? any demand for it? can't go much bigger, but polished aluminum might look dope. Same price as water pump maybe? $50?

Manifold spacer?

Anything else?

I could actually go for a set of tow hooks. Speed Ventures now requires them for their tracks days and same goes for NASA for HPDE. I think you can use the locations of the OE tow hooks, but then make up the cool aluminum ones like on DOG II.

Just throwing out an idea.

brake master cylinder stopper/support?

^ that would be good too.

I'll look into that. Not sure about the tow hooks...

People might be interested in quality machined hubcentric wheel spacers, maybe a few different thicknesses.

The problem always has been the cost of studs. H&R is still the best deal.

The ARP studs are cheap and track proven. There have been a few people around here that have experienced issues with the H&R studs. I'd like to get some larger spacers but I don't want to end up paying for studs that are useless to me.

G spec aluminum crank handles!!

if youll eventually carrie crank, wp, alt pulley count me in.

stratton.