Thread: VE drive collar?

Hey greg, I've got a drive collar here and I'm not sure if it's DE or VE. It measure's 1 3/8".

VE Spacer on left, DE on right

Best picture ever. =]

Edit: Keep that hosted Greg, I'm going to use it in the How To.

you're the man thank you...guess I have the de drive collar

Check that ruler again. You have the VE one.

So, I'm assuming the spacer that you sell for $12 is 3/8" thick correct?

So my options on a de are either get the spacer and be done with it, or change the drive collar out with a ve drive collar.

Checked it ben, it's 1 3/8" same as the collar on the right.

The one on the left is 1 3/8th unless I'm blind, the one on the right is 1 1/8th........

HAHAHA, I feel like an idiot. I'm not used to seeing a tape with 1/32's on it...we only use 1/16's in construction

The RH is 1 3/16", the LH is 1 3/8". The spacer I now sell is sized to make up the difference between the 2. So you install my current spacer on top of the DE drive, then the pulley. nothing has to be removed from the motor.