Thread: enlighten me on this oil drain conundrum

I was fooling with it earlier today, oil drain is good, but the downpipe isn't going to line up, so I gotta clock it. It doesn't look like much, maybe 1/8".

Sent from my C811 4G using Tapatalk

What am I chop liver? I said to clock it first!

However id love to see how he's going to clock the exhaust housing lol

To answer your question, lynch, yes you're chop liver LOL!

What? I can't rotate the exhaust housing?

Sent from my C811 4G using Tapatalk

You can rotate either housing and/or the center. Basically, you can clock it however you please.

Down here looking at it, it seems like the part of the exhaust side I need to rotate is bolted to the manifold. No worries though, I think I have a way to fit the down pipe.

Sent from my C811 4G using Tapatalk

I have yet to see a t25/28 that you could move the exhaust housing. Please show me how you do that! Lol!

The exhaust housing bolts to the manifold so you cannot move it.

You can move the center section and the compressor side but the dp side doesnt move.

You need a bigger hammer, noob.

Just kidding, you are correct. I'm going to be able to take off a little bit of material on the cross member, I only need 1/8" or so, and there's a piece of sheet metal on the x member I can remove to attain it. Nothing structural.


Sent from my C811 4G using Tapatalk

No you can't.

I'm sorry you're right, you can rotate the center and compressor. Not sure what i was thinking!