Thread: High HP transmission mods

Okay cool the 6 sounds very appealing....just parts sourcing...I got my b15 trans mark over at Marsh tuning this summer, maybe I could get out from underneath it, it was in a grandpa car. 100k or less if I remember correctly


Sent from my iPhone using Tapatalk

There are also a few build threads that contain good info on the 6 speed swap also.

I just sourced a 6 speed on Craig's 20 mins from my house for 600.


Sent from my iPhone using Tapatalk

the whole car?

Unfortunately no, just transmission

I wish I got it all for 600

I would most likely do the machined hubs and axles, make the axle retaining bracket myself, motor mounts Greg's fly, clutch masters set up, maxima hydro set up because of ease, Altima shifter and cables. As basic as possible.

If I do the transmission mods I'd likely be rolling with stock DET pistons and rods when marsh finishes the VE port/polish head job. Worse case I do new rods and pistons in chassis later down the road. It would only be a headgasket and man hours.


Sent from my iPhone using Tapatalk

Thats high IMO for just the trans. I picked up a 2005 the other week for $227 and the 06 I got before that was 285.

Nice, I would obviously negotiate. Where are you getting yours? Maybe it would be cheaper on those junkyard sites


Sent from my iPhone using Tapatalk

found mine through car-part.com

I get my FX500 clutches for around 225-250 shipped. Its THE best clutch Ive ever used for street and strip and it is far more streetable than others such as ACT or whatnot

Where do you get your FX500s?