Thread: DE+T DTC codes help with connecting IACV and EVAP Solenoid correctly

Hey man. Finally got a chance to snap that picture. I'm not 100% sure this is how it's "supposed" to be set up, I just know after connecting it this way I haven't had any DTC's.



Not sure how well the text will show up, the port shown on the left is open to air, middle port goes to the Evap canister, port on the right goes to the plenum.

Hmm ok, That's gonna be tough, I don't have any of the emissions components, no canister, no vacuum lines, no EGR, nothing, just kinda went nuts and yanked it all out lmao

i have my soleniod connected and the solenoid lines are all caped off. i have no egr codes :-) hope that helps

Yep, that's the piece I was talking about. If you want the code gone, all you need is the electrical connector hooked up... It's not tough, just buy one of these solenoids since it sounds like you don't have one. I mentioned earlier where to find some.

So I did some digging, turns out my pigtail from the main harness was a little corroded so I clipped and got a spare pigtail from work to splice in, re-connected the evap solenoid, and codes gone for now, I've driven it over 100 miles so far so we'll see I think it should be good

right on

cool beans

Thank you for all your help again everyone