Thread: gtir manifold w/ 72lb msd injectors

I hve been searching the forums to see what people are doing to fit 72lb msd injectors on the gtir manifold. I seen a few suggestions but not a definte answer. I hve a stock gtir fuel rail & a top fuel feed rail. Any suggestions is greatly appreciated. Thanks in advance.

Bump

Bolt On Affair With Stock Gtir Fuel Rail..

The gtir fuel rail will allow you to run most top feed injectors. In some cases the injector my need to be modified to fully seat in the rail. I ran 50lb inj and 72lb inj on a gtir with out issue. Good luck.

Thanks @se200 &@91sentragti-r. I will b looking at it today. But what about where it sits in the manifold?? Is there a special o ring or use the 444 o rings? Do i hve 2 to do something to that side also?. Thanks fellas.

Manifold side should fit with no problems.

Thanks @se200 i think it has 2 b modified for the rail side & the manifold side bcus it doesnt fit like the 444 does and the end flares out like a little lip. So im figure something out. Thanks bro.