Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: gtir manifold w/ 72lb msd injectors

+ Reply To Thread
Posts: 1-7 of 7
2013-08-22 21:57:12
#1
gtir manifold w/ 72lb msd injectors
I hve been searching the forums to see what people are doing to fit 72lb msd injectors on the gtir manifold. I seen a few suggestions but not a definte answer. I hve a stock gtir fuel rail & a top fuel feed rail. Any suggestions is greatly appreciated. Thanks in advance.
Last edited by rara on 2014-03-29 at 21-16-18.
2014-03-29 21:17:08
#2
Bump
2014-03-30 06:03:59
#3
Bolt On Affair With Stock Gtir Fuel Rail..
2014-03-30 09:40:13
#4
The gtir fuel rail will allow you to run most top feed injectors. In some cases the injector my need to be modified to fully seat in the rail. I ran 50lb inj and 72lb inj on a gtir with out issue. Good luck.
2014-03-30 21:25:34
#5
Thanks @se200 &@91sentragti-r. I will b looking at it today. But what about where it sits in the manifold?? Is there a special o ring or use the 444 o rings? Do i hve 2 to do something to that side also?. Thanks fellas.
2014-03-30 22:07:07
#6
Manifold side should fit with no problems.
2014-03-31 00:39:34
#7
Thanks @se200 i think it has 2 b modified for the rail side & the manifold side bcus it doesnt fit like the 444 does and the end flares out like a little lip. So im figure something out. Thanks bro.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top