Originally Posted by cortrim1 Manny you can just send me your manifold my nismo injectors will fit just fine. Did you buy id1000's that were for the sr20?
Don't hold your breath
These are SR20 specific ID1000s
Worth a try. I hope you get this sorted. I will be moving to id1000's with the next turbo setup.
Originally Posted by ashtonsser You have to get the special cusions for those injectors. The only difference between the ve ports and de ports is the oem cusion size. The bore should be identical. They make the id1000 injectors specifically for the SR motor. The part where the o-ring is is different and is actually non existent. The tip is different, it goes around the cusion and the start of the silver part above the o-ring in the picture is what seats against the custion.
You can see what i mean there. These injectors had no lower o-ring.
By what your describing your better off to purely use the oring seal and bore the manifold out to fit the o-ring. The o-ring seal is more than enough to seal it. Ive been using purely o-ring seal on my new manifold and its never had issues. No seats or cusions.
I was wondering what those little rubber cushions were that came with the IDs, lol. I think I figured it out... I took the lower green rubber o-rings out and replaced them with the little cushions that came with the IDs. Those cushions fit into the inner bore of stock SR cushions. Bolted down the rail, and looks like it will seal. Thanks!
You wont be able to see the silver part. On a ve they will sit lower in. My de mani i had to use the seat kit. They are o ringed cnc ma hined seats for the smaller cusions. On the ve you dont have to use any kit. Just the cusions the id injectors come with.
0 Likes
Be the first to like this post.
1992 Nissan Sentra SE-R - Fully Built SR20VE, BWS400SX Billet 67mm and much more
JMS Racing tuned to 716whp, 423wtq at 29psi
10.5 @ 149.2mph to date I believe the fastest trap speed SE-R, Much more to come with some changes!
I included the stock cushion on mine so it looks like it belongs in the stock port location :nevreness:
[ATTACH=CONFIG]673[/ATTACH]
[ATTACH=CONFIG]674[/ATTACH]
[ATTACH=CONFIG]675[/ATTACH]
[ATTACH=CONFIG]676[/ATTACH]