Thread: Mazworx head stud torque

Just trying to confirm the final torque for the nuts on these head studs. 65lb/ft seemed a little on the low side, but that is what their instructions said. Can anyone confirm from experience?

Sent from my SCH-I535 using Tapatalk 2

1/2" or regular stud?

Regular studs

Sent from my SCH-I535 using Tapatalk 2

ok...sent you some info.

Thanks for the info! Anyone have any experience with the standard size studs? 65lb/ft of torque just seems really low to me...

Sent from my SCH-I535 using Tapatalk 2

I have these on my car torqued to there spec with no issues so far..

65lb/ft sounds perfectly fine. Everybody has been over-torqueing head studs for years around here. Lots of repetition of bad info.

I know the ARP studs for the iron block e30 were spec'd for ~60 ft-lbs. No reason our aluminum blocks would use any more.

thank you for all the feed back! Feeling much better about this build now!

Sent from my SCH-I535 using Tapatalk 2

Gonna bump this thread since its high in google search results to add this....