Thread: 6 speed swap poll - issues?

I would take them top of the VC then go to another sr20 car and compare what you see on the level....

thats what mine looks like too, im gonna make a solid one

have it bolt to the trans and then directly bolt to the frame rail

It could very well be a mis designed rear mount bracket. I did notice my front dogbone mount is in a slightly weirder position. I think this is something Mazworx needs to look into and either remake or find another solution. to me its unacceptable for everyones mounts to be doing that. Out of all the mounts there is the least stress on that trans mount.

I agree 100%. I was looking at the crossmember w/the rear prothane that I swapped out and the middle of the prothane is hammered dogshit in a downward direction. The bushing wasn't that old...it just seems like the rear mount is pulling the trans in a downward direction.

Maybe drill a new mounting hole below the existing one, to raise the tranny up...not sure if there's enough room, can't really tell in the pic below. It should still be addressed by Mazworx imo. I would hate to do something like that and then be told I voided the warranty cause it was modified, or something like that....

pic for ref:

If you unbolt that, does the trans shift upward?

my bushing looks to be heading in this direction as well. I do have both metal discs on each side. i agree, hopefully mazworx can come up with a solution to remedy this situation.

Is anyone in this thread local to Mazworx (FL iirc) or have frequent contact with them. They wouldn't know me from Adam.

Send a email and call. You have the product on your car so you are someone.

I tried jacking up the trans on the back end and it did shift the trans mount bushing back into position..might be the the hole position on the rear mount where the bushing bolt goes..if that makes sense..

I went to the mazworx vendor section and posted this thread there...is this allowed on the forum?

it should be