Welcome to the SR20 Community Forum - The Dash.
SR20 forum logo

Thread: Turbo oil water line kit & hoses?

+ Reply To Thread
Posts: 1-3 of 3
2012-10-31 21:14:09
Turbo oil water line kit & hoses?
Okay I have ordered the following for my SR20VE + T convesrion. (tapping block part)

A. 17.8mm HSS Reduced Shank Twist Drill Bit Shank Diameter 1/2 inch
B. 1/2 - 14 NPT taper Pipe HSS Tap
C. 1/2" Male Thread 2/5" Air Fuel Hose Brass Barb Fitting Coupler Adapter

What I want to know is where can I get a full oil water line kit including washers, bolts etc.

The turbo I am using is a Gti-r Garrett Gt28 turbo with 360 thrust bearing.

I need the kit that will work with my turbo and correct hoese to go onto my tapped block barb.

Is the kit below any good? Also where do I get the hoses to go over the barb?
Does anyone have any closer pictures of theie set up?

Turbo Oil Water line kit Garrett Ball Bearing GT28 GT30 | eBay

Any other links?

p.s a few pictures of the set up so far.

Last edited by andy sunny gti on 2012-10-31 at 21-23-51.
2012-11-01 08:33:50
2012-11-01 09:29:07
GT2560R on a BB manifold set up direct fit

And a T25 on a GTiR manifold not so direct?

Thats interesting I just put a ball bearing t25 on my bluebird mani and I had to bend the oil drain straight to get it to work. Chris, I think that might be a journal bearing oil drain as I had to notch the holes on mine as well to get it to work. I just don't get why I had to bend mine straight.

That's a GT2560R on a Bluebird manifold, and as you can see, the drain lines up perfectly.
On a GTiR manifold, it won't line up nearly as well, but a short piece of hose will still work fine.
I'm not sure where I got that drain, but the center to center meassurement on the bolt holes is too large, and I'm going to need to slot the holes.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)

    Back to top