Thread: Turbo oil water line kit & hoses?

Okay I have ordered the following for my SR20VE + T convesrion. (tapping block part)

A. 17.8mm HSS Reduced Shank Twist Drill Bit Shank Diameter 1/2 inch
B. 1/2 - 14 NPT taper Pipe HSS Tap
C. 1/2" Male Thread 2/5" Air Fuel Hose Brass Barb Fitting Coupler Adapter


What I want to know is where can I get a full oil water line kit including washers, bolts etc.

The turbo I am using is a Gti-r Garrett Gt28 turbo with 360 thrust bearing.

I need the kit that will work with my turbo and correct hoese to go onto my tapped block barb.

Is the kit below any good? Also where do I get the hoses to go over the barb?
Does anyone have any closer pictures of theie set up?

Turbo Oil Water line kit Garrett Ball Bearing GT28 GT30 | eBay

Any other links?

p.s a few pictures of the set up so far.

https://www.google.co.uk/search?sourceid=navclient&aq=&oq=sr20ve+turbo+oil+and+water+lines&ie=UTF-8&rlz=1T4ADFA_enGB490GB491&q=sr20ve+turbo+oil+and+water+lines&gs_l=hp....0.0.1.7652...........0.VFh59UtzBdU

GT2560R on a BB manifold set up direct fit



And a T25 on a GTiR manifold not so direct?

Thats interesting I just put a ball bearing t25 on my bluebird mani and I had to bend the oil drain straight to get it to work. Chris, I think that might be a journal bearing oil drain as I had to notch the holes on mine as well to get it to work. I just don't get why I had to bend mine straight.





That's a GT2560R on a Bluebird manifold, and as you can see, the drain lines up perfectly.
On a GTiR manifold, it won't line up nearly as well, but a short piece of hose will still work fine.
I'm not sure where I got that drain, but the center to center meassurement on the bolt holes is too large, and I'm going to need to slot the holes.