Thread: Looking to upgrade my injectors

link to injectors (could i use these ones):
ID1000 SR20DET RWD Top feed only 11mm (blue) adapter tops | eBay

also would I need to upgrade my fuel rail to use the injectors to the link i posted?

or
is there a better injector option for my setup?

looking to go to a t3/t4 setup with a top mount manifold.

Note: He has a GTI-R engine.

^Thanks! better yet ill post a link to my members ride section where I have my mod list.

link: http://www.sr20-forum.com/members-rides/58867-1993-nx2000-sr20det.html

i thought for sure i would have some replies lol

Yes they should fit if thats what your asking. You will need to get rid of the resistors out of the wiring if they are still there. These are high impedance. I think you can get them in low impedance but I would assume your going with an aftermarket management or a realtime b13 ecu or something along that means. Either way, you need to rewire the injectors without the resistors.

As far as fitting, they should drop right in.

i have a set FS

THANK YOU! Means alot to me that you replied to this thread.
The resistors are still there, so I would need to remove them.
aftermarket management (nemu)
I think I could get that done.
I'm trying to go to a bigger turbo setup. (no clue on what turbo yet)
I sent you a pm a while back.
but thanks for answering my question.
--C.Lawless

What size collars to get when using the GTiR fuel rail/manifold?

Thanks.

14mm iirc