Thread: remove bb manifold

alright guys, so i have searched and searched but have not found anything.

I need to remove the turbo manifold from my bluebird swapped b13 but my only issue is where the eff are the oil lines. This is my first turboed sr so excuse my ignorance. I have another kit off the car where the lines are behind the turbo so my question is how do i go about takin gthe manifold off to replace the gasket. I know where the coolant line goes so that isn't an issue i just don't know about the oil. I am hard pressed for time and would like to know what i have to do before i try and do it. any input is appreciated!

thanks in advance

You dont remove the lines from the turbo itself. You need to undo the hose for one of the coolant lines that goes around to the coolant pipes on the right-side of the motor, the other coolant port is on the block itself held on with a banjo bolt, remove that and same goes with the oil feed line, banjo bolt on the block, then loosen the clamp for the oil drain to the block. Then undo the manifold nuts after everything else is disconnected from the turbo such as the intake and compressor outlet pipe and chargepipe. Then you should be able to remove the manifold and turbo together.

thank you ashton for replying and helping to ease a headache i will jump on this asap.