Thread: Turbo oil and water fittings

Anyone have experience with the custom steel kit below or recommend a better and/or better value kit?

Also would the straight or 45* drain be better on a t28 set up?
Thanks

Turbo Fittings

I know of the gofastdepot oil line kit but not too sure of the oil pressure gauge location (no idea if that is a good place as most seem to tap their oil pan). Plus I like the idea of have both water and oil done.

Thanks

nobody taps their oil pans here...and search please there are a million threads for this.

Try this.
http://www.sr20-forum.com/gofastdepot/10187-turbo-oil-feed-line-kit-question.html

And this.
http://www.sr20-forum.com/turbo/9321-where-buy-turbo-oil-drain-barb-bung-also-90-straight.html

For oil stuff.

You might try reading my build thread too. At least peruse the table of contents.

http://www.sr20-forum.com/forced-induction-turbo/48076-how-drill-tap-your-block-turbo-oil-drainage.html

I've been all over your build thread like a fat kid on cake. I just have not heard much about the custom steel product which is what my questions was meant to primarily be about.

ps I have a DET block so I have no need to tap the block etc.

I like the GFD turbo oil feed a lot. I would do it again. Unless you don't need the pressure sensor, in which case just buy yourself a 3 or 4 foot section of AN-3 line and a couple adapters and be on your way.

For oil drain, I like OEM.

For water lines, the CS setup or something similar is the way to go IMO.