Thread: New setup and build....Updated 5/25/12...723whp!!!!!!

do the sleeves stick up above the step as well??

Slacknutz

That should be Justins user name. hahaha.

As for the sleeves stepped down around the sleeve where the coolant passages are so yes they stick up above that. But they also sit slightly above the deck of the block to allow a tighter seal around the cylinders.

Basicly providing the same thing as what o-ringing the block would do but better as you have more surface contact than an o-ring. Most of the big honda guys are moving from o-ringing to stepped deck blocks as they seem to work better for obvious reasons.

Less typing, more wrenching Ashton.

lol, working on finishing up my wiring harness. Couple more clips to install and Im finished with that.

Good on you sir.

A garage is definitely a step in the right direction over the sand lot you used to build motors in.

stop it, i installed my 7pin connector/brake control/etc for my trailer today, and dont forget, i have work, school, daughter, dinner to cook, and a nagging girlfriend lol



yeah right no slacking here...i see tons of it over your way, your wife has been putting in more hours than you have by the looks of it



agreed



yes, yes indeed...garages are awesome

Working Hard

LOL. Jesus the man looks fukin stressed. Go give him some buns!

"Fkn wiring"