Thread: New setup and build....Updated 5/25/12...723whp!!!!!!

yeah, it sucks. My whole back yard is dirt and my garage is not by any means sealed so yeah. The entire car is pretty dusty. Except the inside, lol Amazingly the inside is still pretty clean the way I left it.

Looks dope. My trunk should be here soon.

Dude you must be use to that. If my car ever got covered in sand like that I would have a heart attack!!!

very nice

yeah, not much I can do. That is from 6 months of sitting in the garage. Just the way it goes. It washes off so im not too worried about it. Last thing I have to do before I leave is get it out of the garage and pull the motor out which should take me all of about 20 minutes being the harness and everything is already disconnected and then im gonna remount my shifter box a tad bit higher. Its sitting too low right now. I have to trim out around the shifter opening a bit to do so. Thanks for the kind words guys. Ill keep it updated as I purchase parts and stuff.

Dude it looks awesome. I want one!

Well, im leaving the motor in till I get back. Just dont want to dissasemble it yet and have everything sit. So instead i decided to redo my catch can and fuel lines. Black lines w/ Blue fittings. I mounted my catch can on the drivers side where the wiper linkages would have normally been. Came out pretty clean and will be hidden out of site and stealth looking lines.

Again dont mind the dirt. lol

Looks very nice!
Yeah in AZ its hard not to have dust like that, haha

I'll take Dirt over Smog hahaha

Nice Ashton!!!!!!!!

And thats the truth, hahaha. No smog, no safety inspection, no emissions. Ill take the dirt any day.

A little teaser pic of the manifold test fitted on my vvl motor ready for teardown when I get back. Definitely beefy. Fitment to the firewall is going to be close though. I gave him measurements and he used every bit of it. Good thing i have solid mounts. I have about 1/2"-3/4" to play with of clearance from my measurements. Ill have to hammer down the small shelf that is towards the top of the firewall to allow full clearance as it will be right up against it if not touching it. No biggie.



Ill see you guys at the convention. Heading back overseas tomorrow morning. 7 more months and ill be back to finish things up before the convention. Hope the next 7 months goes by as quick as the first 6 months did.