Thread: Running compressor inlet kit??

Want to run open turbo what do I need to do it? Hers what I have..

1.Emanage ,
2.Z32 Maf,
3. 70-1 turbo <4inch Inlet>
4. Greddy Type-R





Are there any negatives\positives to running the turbo an maf in this sequence. I can still run the BOV open right? Good lookin in advance


Dredd Out

Run blow through and have the BOV before the maf.

So to run blow through do I need any additional parts besides what I got? Can I get more info on the performance aspect?

you are going to be runnig a filter or screen over it right?

Yeah of course, a filter most of the time and the inlet kit shown above the rest of the time. Dont want any unneeded debris t f'up da turbo.. Jus want to no what hardware is needed on top of what I already have and negative\positives to running this way..

Anybody?

a few people have reported air leaks from the top of the Z32 when used under pressure (blow through) as it was designed to work under vacuum only. It can easily be fixed by using epoxy resin or similar to re-seal it though.