Thread: GT28R turbo took a dump! vid

My turbo took a dump!
ok now my question is what ball bearing T3 turbo/mani set-up should I purchase?Not too Laggy..I dont want a monster just something solid and dependable..
looking to get a solid 400-450HP with a little room to spare for more HP...
thanks guys in advance..

My build consist of a fully built VE-T:
(Ve head,DET bottom end 8cw crank)
cp pistons 8.5.1 comp
Manley H beam rods
acl race bearings
ve head gasket
Arp main/head studs
supertech S/R,valves/guides
ported and polished
stock cams for now
Nistuned

what you think is my turbo shot?LOL
http://www.youtube.com/watch?v=6XyVmmT6dY0

sc61 with a good flowing manifold, not to expensive and should put you around there

pte sc6262 with a equal length manifold.

Hmmm..good ideas keep'em coming
remember not too laggy only a 1/8th mile track down here..thanks

30r is a solid turbo too

Just make sure you got a nice manifold doesnt have to be equal length

I know go hard or go home!!Idk maybe later on for the drag car,might be overkill for the daily..thanks though

this might be the route im going but what trim?:o

pm cliff he had a nice setup and spooled up pretty damn quick

you can get away with a larger turbo with a ve because the low lobes help spool up the larger turbo. I personally would not put anything smaller than a 30r on a vet setup.

Yes I agree,I will be purchasing the GT3076R .82 A/R..
Now what mainifold would best fit this turbo?

buy my lovefab sst, its just collecting dust right now lol. brand new...t3, v44 gate flange