Thread: how much HP?????

how much do you guys think this setup would put down.

SR20DET block
SR20VE pistons
SR20VE head (stock cams)
Calum basic
Z32 MAF
555cc injectors @ 4bar
Turbonetics 60-1 @ 10lbs
Protech log manifold
3" downpipe
Tial 38mm WG

"I know the log manifold is going to hold it back a lot, but i found a good deal on it."
im shooting for atleast 325 whp

Should be good for 300/325

yeah. i gonna need to find a BIN for "VE, 555cc@ 4 bar, Z32maf" and change out the chips in the ecu

Why ve pistons?

log isn't going to hold you back from 325hp...

just trying something different this time. got them from a frined of mine for cheap. im not trying to run crazy boost levels as i want it to remain reliable. their on DET rods.

please by all means. give feed back. i havent put a head on the block yet so i can still change a few things around. i have a good set of 9.5:1 pistons and may be able to get some 8.5:1s let me know what you think.

Check the old forum.. Think I found one on there before

cant seem to find it. not a lot of VE-T bins out there.

Ok the ve pistons will not
Hold error. If I were you I would just build something similar to what I have de/det pistons clearing the valve will not be an issue on 2.0/1.6 cams.
Insay use de/det pistons they will hold better,just remember if you use de pistons to
Notch the bottom for the oil squirter.
I made a reliable 450 whp on a 60-1 log manifold .det pistons at 21'psi
Good luck