Thread: gt28 help

yo.. im new to this so be nice ahaha i want to buy this.... would it be able to be bolted right on to the stock manifold with out any problems..? i got a sr20det redtop. thanks!


gt28 turbo charger

Intake :3 inch
Outlet: 2 inch
Compressor trim: .60 ar
Compressor Wheel diameter: 54.28 /71.32
Turbine wheel diameter : 45.47 / 52.90
Exhaust trim: .84ar
Turbine flange type: t25 flange
Downpipe flange type : 240sx 5 bolt type
Cooling type: oil cool only
Horsepower rating: 350-400hp
BOLT ON TURBO FOR S13 S14 S15 (SR20 MOTOR)

(wet float bearing)

actuator set at : 14.5psi

Gt2871 r would.get you around.that.hp i believe

alright thanks. but would that turbo be a bolt right on one?

I believe so,but im not a turbo guru.

YES they will bolt right up but you may have to shave the block depending on what manifold you're running. Is this FWD or RWD SR?

rwd.... its the stock manifold. if not what is a good turbo that would fit without any problems.?

i doubt that 14.5lbs would net that whp.

ya but would it be a straight bolt on with no problems?

they will fit, i couldnt say weather or not you will need to do any compression or exhaust turbine housing clocking, depending on your manifold and your setup some slight adjustments might need to be made as with any setup that is basicly custom..

do you have the needed fuel supply that its going to take to get to 400hp or 350hp.?

Oil cool only? Your gonna need plugs for your block then.