Thread: trans problem

i just bought a b13 with a sr20det in it not to long ago. when i bought it the clutch would engage to low so i looked and the clutch cable adjustment was way to low like the cable wouldnt start pulling the lever until it was all the way down. i adjusted it and the clutch feels fine and starts to engage about half way.. now i have no problems i dont drive the car hard i have got on it here and there but nothing serious.. for some reason the gears are hard to go in and reverse grinds now.. any help or opinions as to what it can be?? im going to check the fluid this weekend. the kid i bought it from said he recently put synchromesh in the trans.. thanks

Could have spat a spring out of the centre plate.

make sure u didnt over tighten the cable

so today i adjusted the clutch cable all the way with the threading in the fork and it seems to go into gear better.. idk for some reason it feels like the lever doesnt move all the way.. when you adjust the clutch do you adjust both the cable and the clutch pedal? if pedal needs to be adjusted how is that done.. im new to cable clutches.. thanks
before it would have about 3 inches or so off clutch play before engaging and it would engage all the way at the bottom now it doesnt have much play and engages better.. i feel like the fork isnt pulling the lever back far enough though and the cable has no more threads.. only thing i can think of is adjusting the pedal but idk how it can be done