Thread: W11 into B13 wont start.

I got everything hooked up finally and went to start the car and it cranks over fine but wont start. I had my friend check for spark and he said he couldn't really see anything.

Car has a JWT ECU for my setup.

Where should I start, I checked the fuel lines, they are right.

I put new plugs in the car, and I added a couple grounds and re-grounded my battery(battery is in trunk). Now the battery is dead from trying to start it. I'm looking for ideas on what to check. Thanks.

did you hook up your power transistor? mine is located near the distributor, I think underneath it, without it you won't get spark, I had the same problem, some how I missed it when doing the install

ok first used a jump start cable or a powerful battery to increase the amps. then check for spark and fuel.

once u have spark ,fuel, and the motor time good with compression the motor should start.

The plug under the distributer or the coil? Both are hooked up. Still not starting.

Just got it to start and run for a minute for the first time!!!!!!!! I was missing a plug at the end of the fuel rail, found that plugged it in. I had the coil plugged in with the wrong plug. There was a small little sensor with a 3 prong plug next to the coil that I didn't have, I took it off my dads nx and hooked it up. Then she fired right up.

Bad news is it wouldn't idle at all without me giving it gas. This could be from me not have the air regulator at all, but I am thinking if I bump my idle up a little it might be okay, I gotta put my exhaust on and some other stuff and then I will mess with that.