Welcome to the SR20 Community Forum - The Dash.
SR20 forum logo

Thread: Injector swap help

+ Reply To Thread
Posts: 1-4 of 4
2010-05-25 23:20:13
Injector swap help
Have a question. What is the best way to go about removing the stock injectors and cause the least amount of damage to them? I've read on a few ways others have done it, just wondering if anyone else has any tips.

This is on my other DE motor. When I swapped the injectors on my current car, I bought a set that was already in a rail to avoid the headache of pulling them.
2010-05-26 00:24:17
I think I remember having a friend grab the rail, while I grabbed the injector and twisted on it. Or I just did it by myself. Was not easy. I might have even used my super long needle nose pliers, the end has a loop where they can grab on circular objects and distribute grip evenly.
2010-05-26 00:32:57
I have used hose pliers before. The trick for me was turning them side to side while pulling up. I have also used this method.

SR20 Setup Tips
2010-05-26 05:15:47
Stick a flathead screwdriver under where the plug part of the injector and twist the screwdriver. This will pry against the rail and the injector will pop right out. Very easy.

+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)

    Back to top