Thread: b14 se-r harness on DET

I just got my 96 se-r harness and some of the plugs on the harness are not going to work with my sensors on my engine....does anyone have a write up on what plugs i need to change? I have my b13 harness i used at my disposal.

My det is out of my 92 that was totaled by a stupid drunk and now i am in a wiring nightmare lol

Thanks

Just plug up what plugs up and it will work.

Put in B14 head temp sensor and guage temp senor on the DET and you are done

ok awesome. does the dizzy and coil plugs fit also?

it will if you use a B14 dist

hey buffalo your pm box is full so i figured id continue our conversation here. lol. And i guess if anybody else has had these problems chime in please.

hahah dammit. I ended up just putting the b13 line on it. the only difference is it doesnt have a place for a connector to the harness but oh well. I just noticed tonight when i was putting my shift linkage together that there is no room for the shifter to move because it is touching the stablizer bar. Did you have this problem? And i tried turning it over tonight just to see if it would and i got nothing. everything else works such as all my electronics and stuff. I feel like its the clutch pedal button but i had the clutch floored when i tried to start it. Also i have an extra connector from the ser harness going into the underdash but there is nowhere for it to go. my ga harness has 3 underdash and the ser harness has 4. What do you think is going on? And thanks for all your help. oh and i did end up getting that drive shaft in it was at a wierd angle and it wouldnt go at first but i finally got it.