Thread: SR20DET piston size

I'm measuring on a Samsung Syncmaster 22" widescreen LCD. When I measure it across both of the monitors, and divide by 2, I still get the same measurements?



Hell I figured it's probably close enough for what he's doing.

Ah that is why. Samsungs are known to be out of scale. You have to rotate it into portrait mode to get it right.

or you could notice the 79e casting and know its a stock det piston and look up the specs in a fsm.

Mike -

FSM doesn't give you the specs he's looking for, specifically. I already looked up the FSM. It said that you can cut a can of soup in half, drill a hole thru it, and use it instead?

1)31.74mm
2)21.98-22mm wrist pin actually measures 21.98mm
3)59.50mm

all measurements were taken from a used 54c piston and wrist pin.

a soup can o rly

thanks for your repliy... the reason why i ask these measurements is i m going to use a forged piston from other engine... just wondering if it may fit or not...

What's wrong with Campbells soup, Mike?!

or do you prefer progresso?!

what would the compression be?

I see. there are some that fit the z32 comes to mind but I believe it requires some wrist pin modification.