Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Breaking P11 trans

+ Reply To Thread
Posts: 31-34 of 34
2010-04-28 06:30:10
#31
Originally Posted by Scrildo
Don't forget that the turbo needs a rebuild. Do not try and run it like that!!!!!!


Lol, I'm not gonna run it like that, tekkie's gonna rebuild it
2010-04-29 00:45:49
#32
Originally Posted by N2Boost
Lol, I'm not gonna run it like that, tekkie's gonna rebuild it


Ok good.
2010-04-29 01:06:56
#33
you can think of it this way, the b13/b14/b15/p10/p11 trans was designed to support a 145 crank hp motor from the factor.

The spec v trans/gearbox which if im not mistaken is the same design and gears other than ratio differences and case except bell housing differences as the VQ fwd vehicles which supports a 287hp v6. So the design of the gears was made to support that much power.

So of course its internals are going to be beefier. Its common knowledge and is visible just looking at the differences.

I think the 6 speed will hold up quite well with the 500+whp sr's
2010-04-29 01:51:29
#34
We need to find a way to stuff a gear stack from a T56 off a camaro into our cars. Then it would hold the big power lol.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top