Thread: help me identify my tranny

So I got my tranny in today to replace the one that I pulled because of the synchros going out in my old one and they don't look the same at all.

The one I just got in today is the one on the right with the orange plug in it. Its from a 2002 infiniti G20, non-lsd. The other one on the left is the one I pulled out of my car. From what I can tell the one I had in my car is a b13 is that what it is? CAn I use the same axles or what do I need to go buy?






the old one


the P11 I just got today

I can't see the pictures, but the RS5F50A was used in the B13 and B14 until 1997. You can use the same axles.

Here is a direct link to my gfs photobucket see if that is better. The one on the left is the old one and the one on the right is the new one.

mommy003.jpg picture by sheridan_blount0 - Photobucket

Sorry I meant 32A/V not 50A/V.

I can't view photobucket at work I'll check from iPhone after my teleconference.

driver side axle is different on the p11 you need a se-l driver side axle and you can use the passenger side axle you have.

K that would be great thanks.

K so I used this thread to swap the clutch arm off the b13 to the p11. Everything is pointing to my broken tranny being a b13 except that my b13 already had a p11 speedo sensor in it Also the clutch arm was different than the one in this thread, instead of grinding the corner of the weight off I had to grind the bottom half of it off. My weight is more towards the outside of the clutch arm. http://www.sr20-forum.com/general-maintenance/53-how-p11-b15-transmission-swap-into-b13-b14-p10.html