Thread: Wonder if this will fit?

might be tight, but it would be nice.



3

I am assuming you're trying to put this on your 240? It IS PRETTY
and this would be alot quieter routing the wastegate back to the exhaust, i dont think that's fitting on a fwd, wish it did

is that for the t25 ???

nah, the S14 already have a nice JGS manifold. i would try this on a FWD B13.



nope, evo

Yeah it would be nice. You would most likely have to hack it shortly after where the wg dump routes back in. Then put a 3 bolt flange or v band on and make a downpipe from there.

what turbo would that bolt up to?

O.T. @Keo- What, if any cams did you use with the SC61 set-up you had? what about BC stg 3s, b/c that's what I got If you're getting full boost at around 4500rpm, you would rather have cams with low end power right, to compensate for the later spool compared to t25/28s/disco potatos

The one he has pictured looks like its for an evo8 or 9 turbo.

idk what turbos they use

Is it just me, but I feel like the 240s are the civic of the Nissan world, thos bastards get everything made for their car, while us fwd guys are left out in the cold, constantly fabricating and getting creative. But i know, not enough potential buyers, as a whole, we're too cheap, etc., etc...

Yeah, we get screwed for the most part. But If we were like hondas you could just go to autozone or pep boys and deck out our cars, they would become too common, and we would have to switch to a new platform. I like being original even if i have to custom make everything.

If i wantend bolt on and go i would buy an sti or an evo and call it a day.

very clean looking piece