Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: safc 2 100% throttle problem

+ Reply To Thread
Posts: 1-10 of 16
2009-06-29 23:12:22
#1
safc 2 100% throttle problem
I just got done putting in my safc 2 and its read 100% throttle without me putting the foot on the gas..it just stays at that number no matter what anyone know how to fix it? Am I missing something?
2009-06-29 23:29:25
#2
try to reset it by disconnecting it from the ecu ( the ig power ) and recconncet again. and also your wiring, recheck it. dosent hurt to be sure .
2009-06-29 23:45:01
#3
You need to change the tps sensor setting in the sensor type menu.

Do you have a manual?
2009-06-29 23:45:56
#4
oops.http://www.kaichia.com/media/safc2_user.pdf
2009-06-29 23:47:46
#5
Set the Throttle sensor settings as it says in the manual ( I don't recall which type it is ) and then do a calibration for it on the SAFC. If that fails, re check your wiring.
2009-06-29 23:50:14
#6
The arrow needs to point up.
2009-06-30 01:07:55
#7
Arrow points up, but for some reason everytime I shut my car off it resets the cyclinders to 6 instead of 4, also I have an apexi rsm plugged in to my ECU as well, I just put the power, black ground, and rpm, wires together then wired them into the same place on my ECU, would that make a difference?
2009-06-30 01:08:33
#8
And no i don't have a manuel, and I can't view the one you posted
2009-06-30 01:38:16
#9
wait, you only wired power, gnd, and RPM?

You know there is a throttle one too right?
2009-06-30 01:43:27
#10
lol u misunderstood me...I wired the ground, power, and rpms on my apexi rsm and my apexi safc2 together..then I wired them to my ECU...
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top