Thread: What kind of Intercooler

Yeah i wish, i know its wrong wheel drive. I hear about it enough hanging out with 90% of my friends which have rwd cars. Who knows depending on cost and how my friend nicks awd nx comes together i may go that route in the future.

I would love to get an air intake temp sensor, and post some #'s up. I will have to see what my cash situation is like once the car is back together and running. I think my friend jake said he found a dual sensor gauge that the 911 turbo porsche guys use. If they use it it most likely accurate and expensive. I will have to look into it. I think they would have quite a heat soak issue with a huge topmount in a tiny bay, at least for the older ones.

yea you can still use it but there's bit of trimming that needs to be done....here a pic of the intercooler w/ the bumper fitted w/ working foglights....

^Who is doing this? Sounds like a bad azz project. It would be hard to touch a AWD NX2000.

I like the i/c set up rigged200

I am going to try and fit at least some of my bumper support back on the nx.

Businessman_24 is the one doing the awd set up. Last i talked with him he is trying to get a couple of transmissions from a guy on here. He already has the rear end, sub frame, driveshafts,brakes, rear suspension etc. Its going to be a bit of cutting and welding, also a fuel cell will be needed. Lucky we both know some excellent welders.

Ive got my the GTIR intercooler sitting collecting dust for years....

Had to bring this thread back from the dead. I just recently purchased as CXRacing intercooler, 20x12x3 and this IS NOT going to fit behind the bumper support with A/C condenser. I will have to cut in about 2" on the bumper support in order for this to work. That is the only issue, should have this thing on by the end of the week.

Here are some before and after pics. Just need to add 6" piping to each end so I can put on the couplers and take it out for a test drive. Cutting out that bumper support is a complete PITA. The pic doesn't show the L bracket that will connect to the top of intercooler bracket and then to the whats left of the hood support bracket. Once everything is buttoned back on I will add those pic.

bumper support whats that? lol

x2 LOL I am too lazy to cut mine and try and make it fit with my bumper, also i think it would look stupid because you would actually be able to see the bumper support.

Looks good hybrid det.

Nice job on keeping A/C with BOOST. If I have to do this to the front bumper support, I will.