Crower Billet Rods
Wiesco 89mm Bore 9:1 Coated Pistons
Benson Sleeved and O-ringed Block
Acl bearings all around
280deg cams
hks sprockets
DPR full race ported head (coated)
Jun valve springs retainers and valve guides
Tomie Solid lifters
Cometic Head gasket
blueprinted and balanced bottom end
r/c 1200 cc inj
custom fuel rail and fuel system
10pt roll cage
12gal fuel cell
weldon fuel pump
z32 trans
exedy twindisk
q45 rear end
solid drive shaft
micro tech stand alone ecu
msd blaster coils x4
Peak Boost manifold
apexi exhaust
work VS-XX 18x9 front 18x10.5 rear
wrapped on p-zeros
tanabe 7's with teas controller
footwerks adj arms..
i know im forgetting allot but its a start..
oh and a/c and power steering!..
Can I asked who tuned the car? I'm running a Microtech LT8S and looking for a retune.....Thanks!
Allan
0 Likes
Be the first to like this post.
96 SE-R VVL Bound
07 G35S Sedan (The Daily) 13.82 @ 100mph
Originally Posted by Justasentra SDRmia, nice build specs. What power range are you in or hoping to produce?
well just got off the dyno and did 519 at the wheels but i need a bigger turbo.. still have more room for more power but just need a bigger turbo! the 25g is not cutting it..
Originally Posted by Super Were you @ Speed Injected's dyno tues night?
That's not the same car Mario.
0 Likes
Be the first to like this post.
92' SER -Pulsar/VVL combo on E85, 11.31 ET @134mph, Full weight, street car, A/C and sunroof, PTE 6262 at 19 psi (low boost) Now running Nismotronic SA
73' Datsun 510 with SR20DET (project)
73' Datsun Drag Car in the works