Thread: How to install a bluetooth adapter on nemu v1

Here is how to install a bluetooth adapter into your nemu v1 board.

It took me about 10 minutes. Here is a little tutorial on how to install it.


You are going to need:
Soldering iron with a sharp point.
Solder. I prefer 60/40 rosin core.
A sturdy hand.



First pull the nemu from the ecu.

Next remove this white support bracket. It just unscrews. Be careful not to loose the two washers.


push the header into these 4 holes from the underside of the board.




I used a peace of ducktape to hold the header in place while i worked.



Now start soldering from the top side.



You should be left with something like this.



Reinstall the long white washer and put the board back into the ecu. Connect all the wires and insert the bluetooth adapter.

Now you are all set.

Awesome stuff.