Thread: Beginners Guide to Chipped ECU Tuning

Calum mentioned some other programs that do the same thing, they're just free. I think one he said was Conzult.

Get Nissan Datascan 1.4

It was free

conzult free is quick and easy and will give you codes.

Code 34 - Detonation sensor or circuit. ECU detected an open or short.

They all fuck up. I've got mine turned off. If you have the right xdf on tunerpro you can unclick it.

The B13 RT .xdf posted here will allow you to disable the Knock Sensor, I would keep it on if your boosted though.

Checked continuity on the circuit and the sensor and both are fine according to All Data. Check out my thread in General SR20.

Hey guys, I see this thread is a bit old..but does anyone have a B14 RTV2 xdf file? I'm trying to help a buddy out with a used RTV2 he purchased.

Thanks.

Thread is actually constantly being updated .

I haven't seen any of those! I would figure it would be similar to the RTV1.

Vadim,

Thanks for the reply. I got ahold of Dave after posting my message here and he doesn't even have a xdf for an OBDII RTV2. Nor does he know the memory addresses that are used to trigger the registers. He let me know that code would need to be placed in the ECU so it would know to trigger them.

From some of the older posts I read of Calum's, and some of the comments he made to me personally, the RTV2 was intended to be a development platform. So that if someone was interested in developing code to do all kinds of things in the ECU, it was possible. But he did not do much of the coding, he just provided the platform (which was really his mission from early on.. to provide the ECU's for us to tune, etc..not him).

I don't post on here much, or on G20.net (were I'm an admin), but I have copies of some apps (NDS, Tunerpro RT, Logworks, Calumsult (the Logworks version), drivers, and the non ODBII RTV2 xdf. If I had saw his thread back when it was started, maybe I could have helped out.

Let me know if I can be of assistance in the future.

Regards,