Welcome to the SR20 Community Forum - The Dash.
SR20 forum logo

Thread: Pressure plate hitting bell housing

+ Reply To Thread
Posts: 1-6 of 6
2017-05-30 15:51:56
Pressure plate hitting bell housing
How's it going? I haven't posted here in over a decade but I am putting together a daily driver b13 to commute. I had a ve that I know is in great condition. I installed a new xtd clutch and flywheel set-up. When I go to install the tranny I noticed the engine locked up. I took it back apart and noticed the pressure plate is rubbing up against the inside of the bell housing. Has anyone every had this issue before? I removed the clutch kit and flywheel and re-installed. Same thing. Spinning the motor from the crank pulley as I tinged up the tranny I noticed that just before the last 1/4 thread on the tranny bolt is when it hits. Any info would help. Thanks
2017-05-30 17:52:42
Wrong clutch setup.
2017-05-30 21:49:34
Can you explain? I thought all fwd sr20 kits are the same. Only thing I can think of is that the flywheel is to thick. I ordered another clutch kit but I'm just curious at this point
Last edited by BenFenner on 2017-06-06 at 21-57-13. Reason: Remove duplicate edits.
2017-05-30 21:59:17
You said you ordered a XTD clutch kit and flywheel?
2017-05-31 12:58:51
Is the clutch disc facing the correct way?
2017-06-05 03:50:17
Did u forget the trans/engine spacer?
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)

    Back to top