Thread: grinding p12 bellhousing for 6speed clutch

6speed users, anyone running the ka24de clutch masters fx500 have any clearance issues? If so where are u grinding? I'm currently trying to clearance the bellhousing just trying to get some insight from any1 who's done it already. My first problems spot was the starter area barely hitting the outter ridge of the pressure plate.

I recall this...hope it helps.

http://www.sr20-forum.com/general-sr20/68366-gtir-sr20det-rs6-ka24de-clutch-grinding-into-bellhousing.html#post914354

That's all I was looking for! Thanks!!

But on the thread it says they used s13 flywheel does this meen it could be used or wht could be issues

Sent from my SM-N920P using Tapatalk

I'm using the Gspec flywheel but with the ka24de cm fx500 the pressure plate hits in the exact spot shown in the thread. I was just wondering if that's was the only spot that proposed a problem for clearance. I just used a angle grinder to take a few mm off of the housing there

I'm using a gspec flywheel and ka24E clutch, no grinding required..

Yeah after talkin to a few different people, It sounds like only some bellhousings require grinding and only with the fx500 lol. Weird cause I'd think the casting would be the same across the board. I bet it is the tiny differences between clutchmaster pressure plates.

Action 2MS need grinding also....

i have a action 1ms