Welcome to the SR20 Community Forum - The Dash.
SR20 forum logo

Thread: Building a Transmission Gear Cuff for the P11 2000-2002

+ Reply To Thread
Posts: 41-50 of 92
2014-01-12 13:07:28
Originally Posted by SE-Rican
Dave that is awesome. Great work. Is fitment different for the B15 box?

Rob, it will fit the B15 the same as the P11. The only difference between the two is the final drive. @SE-Rican
Last edited by kevwal on 2014-01-12 at 13-10-27.
2014-01-20 16:21:54
So since I'm waiting on the input shaft bearing I decided to have the model redesigned. The 5th gear has a cone shape that would center the selector so I had another cuff printed to sit in place of the 5th.

2014-01-20 21:33:21
looking good
2014-01-23 20:23:55
Thanks Bro. Got to love 3D Printing. Still waiting on the input shaft bearing to come in but here is what the cuff will look like minus the bearings

2014-01-24 11:52:56
Originally Posted by Dave_SR20
It should fit the B15 as well. It doesn't extend pass the selector forks so it case wouldn't matter

Nice share Dave.

Is this P11 trans non lsd?
2014-01-24 13:06:08
I'm working with a 70V which is LSD.
2014-01-29 23:12:52
Closer.... Had the ID opened up to match the actual bearings that will be used on the gears.

2014-01-29 23:50:51
Looking good bro.
This should work on any 70 series tranny LSD or non LSD.
2014-01-30 22:31:42
The 3D ID printed a bit off from what it should otherwise it wouldn't have cracked.

2014-01-31 00:41:17
Regardless, progress is being made. Good shitttt!
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)

    Back to top