Thread: Building a Transmission Gear Cuff for the P11 2000-2002

Got to look at the diff. Not sure I can do anything there. Only option would be a billet outer case and beefed up pumpkin to accept a flat bearing.

Here is the 1-1 3D printed cuff out of Nylon. It's rounded off to the closest MM just for simplicity purposes. This way i can make adjustments prior to getting the billet cut.

Looking good Dave!

Thanks Doug. 3D Part came in today. Will get it installed tomorrow.

I didn't even know this section was here. I just happened to be checking the new posts and found it.
This is a great idea and glad to see it coming to life. I know Mfactory didn't think it was worth it but we know different.
I will be watching very close. If you need help with anything let me know.

It was a good thing I decided to order it in 3D. Turns out I miscalculated the distance between shafts. Corrected print should be here tomorrow

That's all part of fabricating. The case is actually what keeps the shafts in place and it's impossible to measure with it on.

Here is the quick and dirty. So far so good. I might not need spacers but I wouldn't be able to tell until I press the reverse gear and upper bearings back in but I can't just yet since my input shaft bearing was messed up from the start. When I get the input shaft I can install it with the upper case to make sure we're all good and then I'll make it out of actual billet

awesome dave people have been stepping it up lately its really great to see

Thanks Alex. I hoping everything works out for the best. The actual billet pc will be tested on the dyno and track. Gives me encouragement to actually finish my car too lol