Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: How to: RS6 6 speed swap guide

+ Reply To Thread
Posts: 131-140 of 285
2012-11-25 00:07:45
#131
No there is no issues with it. Matter fact if its a street car I highly recommend welding them together.
2012-11-25 05:20:24
#132
Has anybody tried to use a gtir clutch master cylinder ?
2012-11-25 05:22:06
#133
Originally Posted by boostednx
Has anybody tried to use a gtir clutch master cylinder ?


From what I hear, you can use it with no issues.
2012-11-25 05:23:47
#134
Originally Posted by SE-Rawkus
Originally Posted by boostednx
Has anybody tried to use a gtir clutch master cylinder ?


From what I hear, you can use it with no issues.

From what I seen online it looks like a direct bolt in item and can be easily had.
2012-11-25 05:48:33
#135
i thought mazworx had plenty...?
2012-11-25 16:04:18
#136
I got my slave and bellhousing from Greg at Gspec. He was $55 cheaper on the bell than mazworx. They told me the P12 stuff was on backorder and didn't know when they could get it, but Greg got it to me in a week. They do have the conversion mount kits though.
2012-11-27 19:01:48
#137
Originally Posted by ashtonsser
Alright people. Looks like the hubs are able to be drilled and resplined for the b15 axles without a problem. Cost should be around 100 bucks for a pair of hubs that you send in to have done.

If you need them done, contact Frank at DSS. He has all the information you need.


Just talked to Tad. My hubs will be ready at the end of the week.
2012-11-27 19:48:15
#138
Originally Posted by ashtonsser
Alright people. Looks like the hubs are able to be drilled and resplined for the b15 axles without a problem. Cost should be around 100 bucks for a pair of hubs that you send in to have done.

If you need them done, contact Frank at DSS. He has all the information you need.


So, these are the B13 CV on the hub end so you don't have to swap hubs? You have these redone and then installed on your B15 tranny side CV and shaft?
2012-11-27 20:02:39
#139
The B13 hubs are being splined bigger to fit spec-v axles.
2012-11-27 20:36:51
#140
Originally Posted by unijabnx2000
The B13 hubs are being splined bigger to fit spec-v axles.


That's what I was hoping for...
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top